Finishing profile with a gutter (40 mm overhang) for laying on a prepared gradient coating. We get a clean and perfect ending of the tiles by using a closed edge. It is suitable for constructional structures with one or two component elastic waterproofing or with a separator film CS

Outside corner for BA RT adjustable balcony and terrace profile, 90˚

Outside corner for BD20 40 DRIP PLUS balcony and terrace profile, 135˚

Outside corner for BD 40 DRIP balcony and terrace profile, 135˚

Outside corner for BD20 40 DRIP PLUS balcony and terrace profile, 90˚

Finishing profile with drip edge (40 mm overhang) for installation of sloped screed. Suitable for construction with contact isolation and separation, particularly suitable for construction with the bonded drainage. At the bottom of the profile are drainage holes to ensure complete drainage of water vapor. Using perforated bottom edge to get the perfect finishing coverings

The set of the connectors is used to cover the two parts of profile, an expansion gap between the ends of the profile should not be less than 2 mm

*Finishing profile with a gutter (40 mm overhang) for laying on a prepared gradient coating. Suitable for constructional structures with contact waterproofing as well as with separator, diffusion and waterproofing film. In the lower part of the profile, there are drainage holes, which provide perfect drainage of water vapour or possibly water, which may penetrate between the profile and tiling ...

The set of the connectors is used to cover the two parts of profile, an expansion gap between the ends of the profile should not be less than 3 mm

The connector is used to cover the two parts of profile, an expansion gap between the ends of the profile should not be less than 2 mm

Finishing profile with short drip edge (20 mm overhang) for installation on finished screed fall. The profile is suitable for use with plaster and poured floors. Profile allows perfect drainage of balconies and terraces

The connector is used to cover two parts of profile