Plastic cutter for anchor counter-sunk assembly in EPS

Features:

• The counter-sunk assembly significantly reduces the thermal bridge created by the anchor
• The anchor used are by 15-20 mm shorter compared to the the surface assembly
• No need to apply mortar on the anchoring point
• Quick and easy implementation
• In combination with an EPS cap suitable for repair of poorly drilled holes
• The cutter is not designed to be used with mineral wool

Instruction for use:

Fix the cutter in the drill with a chuck. Cut the insulation with slightly pressing movement until the cutter stop edge touches the insulation surface. Then install the anchor and especially, in the case of hammered anchor, prevent the anchor plate from being inserted too deep into the insulation. After the anchor assembly completion put the plug on and use a trowel to press into the final position flush with the insulation surface. The cutter life may be extended if you prevent the cutter from overheating

Packaging and storage:

Packed in plastic bags