The fixing for anchoring in insulation. To fix lightweight fixtures in plastered and non-plastered insulating boards.

Advantages-application:

• used for fastening of light loads, mailboxes, signs, motion indicators
• the FID 50 is used in thin insulating boards from 50mm; * the FID 90 is used in thicker insulating boards and can bear higher loads
• manufactured in impact-resistant plastic
• simple fast installation with standard screw bit
• the geometry of the FID allows for a simple installation in thin layers of plaster, without the need for pre-drilling, thus saving a stage of installation
• the special spiral thread taps itself in the insulating board
• the bit mounting allows for setting with standard tools, thus allowing for a fast and economic installation
• since the anchor is set exclusively in the insulation itself, fixtures can be installed without thermal bridges

Approved for:

• polystyrene foams
• polyurethane

Installation tips:

• the FID can be set in the insulating board with a cordless screwdriver or by hand
• fixtures are fixed with a 4.5 mm screw for the FID 50, and with a 6 mm screw for the FID 90
• in order to prevent undesirable ingress of water into the insulation, the fixing edge should be sealed with construction silicone or acrylic sealant after installation is completed
• after the fixing installation, the corresponding component is fastened with a chipboard screw