Post-installed mineral wool cap reduces heat transmission and results in a homogenous insulation surface

Features and benefits:

• Cost-saving solution, as countersunk installation allows selection of shorter fixings.
• Results in homogeneous and smooth insulation surface
• Post-installed cap reduces heat transmission at fixing points

Applications: Mineral wool (MW) boards

Installation guide:

• Pre-assamble TFIX-8S-SETTING DEVICE with TFIX-8S fixing and than make installation of screw fixing
• Drill a hole of required diameter and depth
• Lightly tap the plastic sleeve through the insulation material into hole with a hammer, until fixing depth is reached
• When using the TFIX-DEVICE the teeth should be embedded in the insulation material after hammering.
• Tighten screw (using special TFIX-8ST-TOOL setting tool) until fixing is secure and flush with insulation material
• Embedment depth of min 25mm in A,B,C,D materials and 65mm in Aerated Concrete Block
• Drilling depth of min 40mm in A,B,C,D materials and 80mm in Aerated Concrete Block
• Insert cap into countersunk hole in insulation.